Security Restrictions - Cisco 7970G - IP Phone VoIP Administration Manual

Chapter 1 An Overview of the Cisco Unified IP Phone

Security Restrictions

Cisco Unified IP Phone 7970G/7971G-GE Administration Guide for Cisco Unified Communications Manager 6.1
OL-14626-01
Disabled—If the switch does not support multi-domain authentication,
–
disable the Voice VLAN and consider assigning the port to the native
VLAN. See the
more information.
Enter MD5 Shared Secret—If you disable 802.1X authentication or perform
•
a factory reset on the phone, the previously configured MD5 shared secret is
deleted. See the "802.1X Authentication and Status" section on page 4-51
more information.
A user cannot barge into an encrypted call if the phone that is used to barge is not
configured for encryption. When barge fails in this case, a reorder tone (fast busy
tone) plays on the phone on which the user initiated the barge.
If the initiator phone is configured for encryption, the barge initiator can barge
into an authenticated or nonsecure call from the encrypted phone. After the barge
occurs, Cisco Unified Communications Manager classifies the call as nonsecure.
If the initiator phone is configured for encryption, the barge initiator can barge
into an encrypted call, and the phone indicates that the call is encrypted.
A user can barge into an authenticated call, even if the phone that is used to barge
is nonsecure. The authentication icon continues to appear on the authenticated
devices in the call, even if the initiator phone does not support security.
Understanding Security Features for Cisco Unified IP Phones
"Security Configuration Menu" section on page 4-38 for
for
1-25