Determining the MAC Address of a Cisco Unified IP Phone
Deploying a Phone in an SCCP and SIP Environment
Determining the MAC Address of a Cisco
Unified IP Phone
Cisco Unified IP Phone 7970G/7971G-GE Administration Guide for Cisco Unified Communications Manager 6.1
2-20
Chapter 2
To deploy Cisco Unified IP Phones in an environment that includes SCCP and
SIP and in which the Cisco Unified Communications Manager Auto-Registration
parameter is SCCP, perform these general steps:
Set the Cisco Unified Communications Manager auto_registration_protocol
1.
parameter to SCCP.
From Cisco Unified Communications Manager Administration, choose
System > Enterprise Parameters.
2.
Install the phones.
Change the Auto Registration Protocol enterprise parameter to SIP.
3.
Auto-register the SIP phones.
4.
Several of the procedures that are described in this manual require you to
determine the MAC address of a Cisco Unified IP Phone. You can determine the
MAC address for a phone in any of these ways:
•
From the phone, choose Settings > Network Configuration and look at the
MAC Address field.
•
Look at the MAC label on the back of the phone.
Display the web page for the phone and click the Device Information
•
hyperlink.
For information about accessing the web page, see the
Page for a Phone" section on page
Preparing to Install the Cisco Unified IP Phone on Your Network
8-2.
"Accessing the Web
OL-14626-01