Cisco 7970G - IP Phone VoIP Administration Manual page 195

Chapter 7 Viewing Model Information, Status, and Statistics on the Cisco Unified IP Phone
Table 7-2 Status Messages on the Cisco Unified IP Phone 7970 Series
Message
BootP server used
CFG file not found
CFG TFTP Size
Error
Cisco Unified IP Phone 7970G/7971G-GE Administration Guide for Cisco Unified Communications Manager 6.1
OL-14626-01
Description
The phone obtained its IP address from
a BootP server rather than a DHCP
server.
The name-based and default
configuration file was not found on the
TFTP Server.
The configuration file is too large for
file system on the phone.
Possible Explanation and Action
None. This message is informational
only.
The configuration file for a phone is
created when the phone is added to the
Cisco Unified Communications
Manager database. If the phone has not
been added to the
Cisco Unified Communications
Manager database, the TFTP server
generates a
CFG File Not Found
response.
Phone is not registered with
•
Cisco Unified Communications
Manager.
You must manually add the phone
to Cisco Unified Communications
Manager if you are not allowing
phones to auto-register. See the
"Adding Phones with Cisco
Unified Communications
Manager Administration" section
on page 2-16 for details.
If you are using DHCP, verify that
•
the DHCP server is pointing to the
correct TFTP server.
If you are using static IP
•
addresses, check configuration of
the TFTP server. See the
"Network Configuration Menu"
section on page 4-7
assigning a TFTP server.
Power cycle the phone.
Status Menu
for details on
7-5