Adding Phones With Cisco Unified Communications Manager Administration - Cisco 7970G - IP Phone VoIP Administration Manual

Adding Phones to the Cisco Unified Communications Manager Database
Note
Adding Phones with Cisco Unified Communications Manager
Administration
Cisco Unified IP Phone 7970G/7971G-GE Administration Guide for Cisco Unified Communications Manager 6.1
2-16
Chapter 2
To implement TAPS, you or the end-user dial a TAPS directory number and follow
voice prompts. When the process is complete, the phone will have downloaded its
directory number and other settings, and the phone will be updated in
Cisco Unified Communications Manager Administration with the correct MAC
address.
Auto-registration must be enabled in Cisco Unified Communications Manager
Administration (System > Cisco Communications Manager) for TAPS to
function.
When you configure the cluster for mixed mode through the Cisco CTL client,
auto-registration is automatically disabled. When you configure the cluster for
non-secure mode through the Cisco CTL client, auto-registration is automatically
enabled.
Refer to Cisco Unified Communications Manager Bulk Administration Guide for
detailed instructions about BAT and about TAPS.
Related Topics
Adding Phones with Auto-Registration, page 2-14
•
Adding Phones with Cisco Unified Communications Manager
•
Administration, page 2-16
Adding Phones with BAT, page 2-17
•
You can add phones individually to the Cisco Unified Communications Manager
database using Cisco Unified Communications Manager Administration. To do
so, you first need to obtain the MAC address for each phone.
For information about determining a MAC address, see the
MAC Address of a Cisco Unified IP Phone" section on page
After you have collected MAC addresses, in Cisco Unified Communications
Manager Administration, choose Device > Phone and click Add New to begin.
Preparing to Install the Cisco Unified IP Phone on Your Network
"Determining the
2-20.
OL-14626-01