Using Cisco Unified Ip Phones With Different Protocols; Converting A New Phone From Sccp To Sip - Cisco 7970G - IP Phone VoIP Administration Manual

Using Cisco Unified IP Phones with Different Protocols

Using Cisco Unified IP Phones with Different
Protocols

Converting a New Phone from SCCP to SIP

Step 1
Step 2
Cisco Unified IP Phone 7970G/7971G-GE Administration Guide for Cisco Unified Communications Manager 6.1
2-18
Chapter 2
The Cisco Unified IP Phone can operate with SCCP (Skinny Client Control
Protocol) or SIP (Session Initiation Protocol). You can convert a phone that is
using one protocol for use with the other protocol.
This section includes these topics:
Converting a New Phone from SCCP to SIP, page 2-18
•
• Converting an In-Use Phone from SCCP to SIP, page 2-19
Converting an In-Use Phone from SIP to SCCP, page 2-19
•
Deploying a Phone in an SCCP and SIP Environment, page 2-20
•
A new, unused phone is set for SCCP by default. To convert this phone to SIP,
perform these steps:
Procedure
Take one of these actions:
To auto-register the phone, set the Auto Registration Phone Protocol
•
parameter in Cisco Unified Communications Manager Administration to SIP.
To provision the phone using the Bulk Administration Tool (BAT), choose the
•
appropriate phone model and choose SIP from the BAT.
To provision the phone manually, make the appropriate changes for SIP on
•
the Phone configuration window in Cisco Unified Communications Manager
Administration.
Refer to Cisco Unified Communications Manager Administration Guide for
detailed information about Cisco Unified Communications Manager
configuration. Refer to Cisco Unified Communications Manager Bulk
Administration Guide for detailed information about using the BAT.
If you are not using DHCP in your network, configure the network parameters for
the phone.
Preparing to Install the Cisco Unified IP Phone on Your Network
OL-14626-01