Attaching The Cisco Unified Ip Phone Expansion Module 7914 (Sccp Phones Only) - Cisco 7970G - IP Phone VoIP Administration Manual

Attaching the Cisco Unified IP Phone Expansion Module 7914 (SCCP Phones Only)

Attaching the Cisco Unified IP Phone Expansion
Module 7914 (SCCP Phones Only)
Step 1
Step 2
Cisco Unified IP Phone 7970G/7971G-GE Administration Guide for Cisco Unified Communications Manager 6.1
3-10
Related Topics
Before You Begin, page 3-2
•
Attaching the Cisco Unified IP Phone Expansion Module 7914 (SCCP
•
Phones Only)
Adjusting the Placement of the Cisco Unified IP Phone, page 3-12
•
Configuring Startup Network Settings, page 3-17
•
The Cisco Unified IP Phone Expansion Module 7914 can be attached to an SCCP
Cisco Unified IP Phone 7970 Series to extend the number of line appearances or
speed dial buttons. You can customize the button templates for the Cisco Unified
IP Phone Expansion Module 7914 to determine the number of line appearances
and speed dial buttons. See the
page 5-25 for details.
The Cisco Unified IP Phone Expansion Module 7914 is not compatible with SIP
phones.
You can attach a Cisco Unified IP Phone Expansion Module 7914 to a phone:
• When you initially add the phone to Cisco Unified Communications Manager
by selecting 7914 14-Button Line Expansion Module in the Module 1 or
Module 2 fields and selecting the appropriate expansion module firmware.
See Step 6 in the following procedure.
After the phone is configured in Cisco Unified Communications Manager.
•
To configure the Cisco Unified IP Phone Expansion Module 7914 on an SCCP
Cisco Unified IP Phone, follow these steps:
Procedure
Log in to Cisco Unified Communications Manager Administration.
Cisco Unified Communications Manager Administration displays.
From the menu, choose Device > Phone.
Chapter 3 Setting Up the Cisco Unified IP Phone
"Modifying Phone Button Templates" section on
OL-14626-01