Cisco 7970G - IP Phone VoIP Administration Manual page 24

What Networking Protocols Are Used?
Table 1-1 Supported Networking Protocols on the Cisco Unified IP Phone (continued)
Networking Protocol
Hypertext Transfer
Protocol (HTTP)
IEEE 802.1X
Internet Protocol (IP)
Link Layer Discovery
Protocol (LLDP)
Cisco Unified IP Phone 7970G/7971G-GE Administration Guide for Cisco Unified Communications Manager 6.1
1-6
Purpose
HTTP is the standard way of
transferring information and moving
documents across the Internet and the
web.
The IEEE 802.1X standard defines a
client-server-based access control
and authentication protocol that
restricts unauthorized clients from
connecting to a LAN through
publicly accessible ports.
Until the client is authenticated,
802.1X access control allows only
Extensible Authentication Protocol
over LAN (EAPOL) traffic through
the port to which the client is
connected. After authentication is
successful, normal traffic can pass
through the port.
IP is a messaging protocol that
addresses and sends packets across
the network.
LLDP is a standardized network
discovery protocol (similar to CDP)
that is supported on some Cisco and
third-party devices.
Chapter 1 An Overview of the Cisco Unified IP Phone
Usage Notes
Cisco Unified IP Phones use HTTP
for the XML services and for
troubleshooting purposes.
The Cisco Unified IP Phone
implements the IEEE 802.1X
standard by providing support for the
EAP-MD5 option for 802.1X
authentication.
When 802.1X authentication is
enabled on the phone, you should
disable the PC port and voice VLAN.
Refer to the "Supporting 802.1X
Authentication on Cisco Unified IP
Phones" section on page 1-22
additional information.
To communicate using IP, network
devices must have an assigned IP
address, subnet, and gateway.
IP addresses, subnets, and gateways
identifications are automatically
assigned if you are using the Cisco
Unified IP Phone with Dynamic Host
Configuration Protocol (DHCP). If
you are not using DHCP, you must
manually assign these properties to
each phone locally.
The Cisco Unified IP Phone supports
LLDP on the PC port.
for
OL-14626-01