Multitech SocketModem iCell MTSMC-G2-IP At Commands Reference Manual page 87

Part 6 – Commands for GPS-Enabled Devices
GPS Configuration Examples
AT#GPSPREFIX="&&"<CR>
AT#GPSURAIS="ID1111"<CR>
AT#GPSGPRMC=1<CR>
AT#GPSGPGGA=0<CR>
AT#GPSGPGLL=0<CR>
AT#GPSGPGSA=0<CR>
AT#GPSGPGSV=0<CR>
AT#GPSGPVTG=0<CR>
AT#VGPS<CR>
***The following command starts the GPS sending. The message will be sent if the UIP device is
connected to the network. (CONNECTIONSTART has been issued)
AT#GPSINTERVAL=5<CR>
AT#GPSINTERVAL=0<CR>
The following example message would be sent over the network using UDP every 5 seconds (The
$GPRMC would have different data however)
&&ID1111$GPRMC,223750.00,A,4502.2467,N,09302.4844,W,57.00,97.29,131104,2.5,E,A*20<CR><LF>
Universal IP AT Commands Reference Guide (Document S000457G)
Downloaded from Elcodis.com electronic components distributor
Chapter 16 – Commands for GPS-Enabled Devices
Prefix (Requirements provided by backend service)
Unique ID (Requirements provided by backend service)
Enable GPRMC message (Requirements provided by backend
service)
Disable GPGGA message (Requirements provided by backend
service)
Disable GPGLL message (Requirements provided by backend service)
Disable GPGSA message (Requirements provided by backend
service)
Disable GPGSV message (Requirements provided by backend
service)
Disable GPGLL message (Requirements provided by backend service)
View settings
Timer in seconds that the device will contact the remote server
Disables sending messages
87