Multitech SocketModem iCell MTSMC-G2-IP At Commands Reference Manual page 52

Part 3 – Commands for Wi-Fi Devices
#BOOTMSG – Enable/Disable Boot Message
Description:
Syntax:
Values:
Default:
Examples:
#RESET – Restart the Module
Description:
Syntax:
Values:
Note: After issuing AT#RESET, it can take up to 45 seconds before the MT810SWM-IP is ready to accept AT
Commands. When configuring the MT810SWM-IP using security mode WPA or WPA2, the bootup time will take
longer.
#WATCHDOG – Enable/Disable Watchdog
Description:
Note: The module must be reset to put the command into effect.
Syntax:
Values:
Default Value: 1
Example:
Universal IP AT Commands Reference Guide (Document S000457G)
Downloaded from Elcodis.com electronic components distributor
Chapter 11 – General Commands for the SocketWireless Wi-Fi (MT810SWM-IP)
Enables/disables the boot message.
Set Value: AT#BOOTMSG=<0,1>
View Value: AT#BOOTMSG?
0 Disable
1 Enable
1 Enable
AT#BOOTMSG?
0
OK
AT#BOOTMSG=1
OK
AT#BOOTMSG?
1
OK
AT#BOOTMSG=0
OK
Restarts our module from the command prompt.
AT#RESET
None
Enable/disable Watchdog for the system – reset on HANG.
Set Value: AT#WATCHDOG=<0,1>
View Value: AT#WATCHDOG?
0 Disable Watchdog
1 Enable Watchdog
Enable Watchdog
AT#WATCHDOG?
1
OK
52