Multitech SocketModem iCell MTSMC-G2-IP At Commands Reference Manual page 25

Part 1 – AT Commands for All Universal IP Devices
Chapter 3 – POP3 Commands for All
Set Commands
#POP3HEADERMODE – POP3 Header
Definition:
Syntax:
Values:
Default:
#POP3PORT – Set POP3 Server Port
Definition:
Syntax:
Values:
Default:
#POP3PW – Set POP3 Password
Definition:
Syntax:
Values:
Default:
#POP3SERV – Set POP3 Server Address
Definition:
Syntax:
Values:
Default:
Universal IP AT Commands Reference Guide (Document S000457G)
Downloaded from Elcodis.com electronic components distributor
Universal IP Devices
When receiving an email message, the TCP/IP stack can be configured to send or not to send the
POP3 header over the serial port. The POP3 header contains the From, Cc and Subject fields.
Set Value: AT#POP3HEADERMODE=<value>
View Value: AT#POP3HEADERMODE? or AT#VPOP3, AT#VALL
0 The email header will not be sent over the serial port while retrieving.
1 The email header will be sent over the serial port while retrieving.
1
To reach the POP3 server, the TCP/IP stack software must know the port of the POP3 server
used for retrieving email.
Note: This parameter should be changed only by your network administrator since it depends on
network infrastructure configuration including firewalls, proxy or specific TCP port translation
settings.
Set Value: AT#POP3PORT=<value>
View Value: AT#POP3PPORT? or AT#VPOP3, AT#VALL
5 digits (each digit between 0 and 9 inclusive). Note that numbers above 65,535 are illegal as the
port identification fields are 16 bits long in the TCP header.
110
Password for POP3 account. To retrieve email messages sent to a specified email address, the
TCP/IP stack software must know the POP3 password that has been set for that email account.
Set Value: AT#POP3PW="<value>"
View Value: AT#POP3PW? or AT#VPOP3, AT#VALL
Alphanumeric ASCII text string up to 64 characters.
None
To retrieve email messages, the TCP/IP stack software must know the address of the POP3
server that is to be used. The POP3 server must be the one where the specified email account is
hosted (which is not necessarily maintained by the local ISP).
Set Value: AT#POP3SERV="<value>"
View Value: AT#POP3SERV? or AT#VPOP3, AT#VALL
32-bit number in dotted-decimal notation (i.e., xxx.xxx.xxx.xxx) or
Alphanumeric ASCII text string up to 120 characters if DNS is available.
None
Chapter 3 – POP3 Commands
25