Multitech SocketModem iCell MTSMC-G2-IP At Commands Reference Manual page 60

Part 3 – Commands Wi-Fi Devices
#WLANSCAN – Scan Wireless Networks
Description:
Syntax:
Example:
#WLANUSEPROFILE – User Profile
Description:
Syntax:
Values:
#WLANGETRSSI – Received Signal Strength
Description:
Syntax:
Values: Return a signal strength value from -256 to 255.
Response
Example:
#WLANACTIVATE – Move Module out of Power Save
Description:
Syntax:
Values:
Universal IP AT Commands Reference Guide (Document S000457G)
Downloaded from Elcodis.com electronic components distributor
Scans all the APs (access points) in the environment and displays information about their settings
and capabilities on HyperTerminal or similar program.
AT#WLANSCAN
ESSID: Plan B
BSSID : 00:08:00:C0:30:99
Channel Num :6
RSSI : -61
Network Type : BSS
Security : No Enc
Capability: 0x1
WLAN Mode: B Mode
Sets and displays the use profile value. If user profile value is set to any value between 1 and 4,
then at the time of user name association, the module first scans for the selected user profile
parameters.
Note: The module must be reset to put the command into effect.
Set Value: AT#WLANUSEPROFILE=<value>
View Value: AT#WLANUSEPROFILE?
1 – 4
This command displays the current received signal strength.
Set Value: AT#WLANGETRSSI
AT#WLANGETRSSI
RSSI : 0
OK
This command moves the module out of Power Save during an active connection. See
#WLANDOZE
Note: The module must be reset to put the command into effect.
Set Value: AT#WLANACTIVATE
NA
Chapter 13 – WLAN Commands for the SocketWireless Wi-Fi (MT810SWM-IP)
60