Multitech SocketModem iCell MTSMC-G2-IP At Commands Reference Manual page 20

Part 1 – AT Commands for All Universal IP Devices
#DOMAIN – Set Domain Name of the Sender
Definition:
Syntax:
Values:
Default:
#RECiADD – Set Email Address
Definition:
Syntax:
Values:
Setting One Email Address / Resetting the Parameter / Getting:
Setting One to Ten Email Address to the RECi Parameter / Resetting the Parameter:
Note 1:
Note 2:
Example:
Default:
#SUBJi – Set Email Pre-Defined Subject Text
Definition:
Syntax:
Values:
Default:
Universal IP AT Commands Reference Guide (Document S000457G)
Downloaded from Elcodis.com electronic components distributor
When sending an email message, the TCP/IP stack software must provide the SMTP server with
the domain name of the sender. In some cases, this domain name may be different from the
domain name included in the sender's email address.
Set Value: AT#DOMAIN="<value>"
View Value: AT#DOMAIN? or AT#VSMTP, AT#VALL
Alphanumeric ASCII text string up to 120 characters.
None
To send email messages, the TCP/IP stack software must know the e-mail address of the
recipient. This email address will appear in the email header sent by the TCP/IP stack software,
in the field 'To:'
The RECi parameter can hold a maximum of 10 email addresses, each email address being at
the most 120 characters long.
Set Value: AT#RECi="<Value>"
View Value: AT#RECi? (replace i with 1, 2, or 3) or AT#VMAILi, AT#VALL
RECi (i = 1, 2, or 3)
Alphanumeric ASCII text string up to 120 characters. The address must be provided in literal
format (for instance xxxxx@company.com).
Set value / reset the parameter: AT#RECi="<Value>" (replace i with 1, 2, or 3)
View value: AT#REC? (replace i with 1, 2, or 3) or AT#VMAILi, AT#VALL
To set 1 to 10 email addresses to the RECi parameter, enter the AT#RECiADD<CR> overwriting
command.
Each email address has to be an alphanumeric ASCII text string, in literal format (for instance,
dev12345678@web.xyz). To add another email address, enter the <CR><LF> pair. To end the
setting, enter the following character: 1A (in ASCII code), generated in a keyboard by CTRL+Z
escape sequence.
This command overwrites all previously set email addresses of the RECi parameter.
If more than ten addresses are entered, the 11th and subsequent addresses until the end
character will be ignored.
AT#REC1ADD<CR>
Email1@domain.fr<CR><LF>
Email2@domain.com<CR><LF>
<CTRL+Z>
None
These parameters contain the pre-defined subject text that will be used by the TCP/IP stack to
compose the email header.
Set Value: AT#SUBJi="<value>" (replace i with 1, 2, or 3)
View Value: AT#SUBJi? (replace i with 1, 2, or 3) or AT#VMAILi, AT#VALL
Alphanumeric ASCII text string up to 120 characters.
None
Chapter 2 – SMTP Commands
20