Multitech SocketModem iCell MTSMC-G2-IP At Commands Reference Manual page 42

Part 2 – Commands for the SocketEthernet IP
#IPNETMASK – Set Subnet Mask
Description:
Syntax:
Responses:
Values:
Default:
#DNSSERV1 – Set DNS Server IP Address
Definition:
Syntax:
Responses:
Values:
Default:
#DNSSERV2 – Set Secondary DNS Server
Definition:
Syntax:
Values:
Default:
Note:
#EMACSPD – Set Ethernet Connection
Description:
Syntax:
Values:
Default:
Universal IP AT Commands Reference Guide (Document S000457G)
Downloaded from Elcodis.com electronic components distributor
Sets the subnet mask.
Note: The module must be reset to put the command into effect.
Set Value: AT#IPNETMASK="<Subnet Mask value>"
View Value: AT#IPNETMASK?
AT#IPNETMASK = 255.255.255.0 returns and OK
AT#NETMASK? returns 255.255.255.0 (Manually Configured) and OK
IP Address in dotted decimal notation (xxx.xxx.xxx.xxxx). "x" = a number between 0-255.
255.255.255.0
In order to translate the server names from literal format into IP addresses, the TCP/IP stack
software implements the Domain Name System (DNS) protocol. The DNS Server IP address
must be specified for use by the TCP/IP stack software.
Set Value: AT#DNSSERV1="<value>"
View Value: AT#DNSSERV1?
AT# DNSSERV1=192.168.0.1 returns and OK
AT# DNSSERV1? returns 192.168.0.1 and OK
32-bit number in dotted-decimal notation (i.e., xxx.xxx.xxx.xxx).
202.56.215.6
In order to translate the server names from literal format into IP addresses, the TCP/IP stack
software implements the Domain Name System (DNS) protocol. The DNS Server IP address has
to be specified for use by the TCP/IP stack software. This secondary DNS server is used in the
case where the primary DNS server does not respond to a
Set Value: AT#DNSSERV2="<value>"
View Value: AT#DNSSERV2?
32-bit number in dotted-decimal notation (i.e., xxx.xxx.xxx.xxx).
202.56.230.6
The Universal IP resolver (DNS Client) has a list that holds up to 4 DNS servers, the first 2 in the
list are populated by the #DNSSERV1 and #DNSSERV2 commands, the 3rd and 4th are
populated by DNS information provided by the ISP or cellular carrier. The list is checked in order
(1-4). This means that user configured name servers will be checked before dynamically
assigned name servers.
Sets the Ethernet connection at 10 or 100 full or half duplex.
AT#EMACSPD=x where x stands for 0,1,2,3,4
AT#EMACSPD=0 Auto Sensing
AT#EMACSPD=1 10Mbis half duplex
AT#EMACSPD=2 10Mbis full duplex
AT#EMACSPD=3 100Mbis half duplex
AT#EMACSPD=4 100Mbis full duplex
AT#EMACSPD? View the current setting. Can view with AT#VALL or AT#VIP also.
AT#EMACSPD=0
Chapter 8 – General Commands for SocketEthernet IP (MT100SEM-IP)
request.
42