Multitech SocketModem iCell MTSMC-G2-IP At Commands Reference Manual page 38

Part 1 – AT Commands for All Universal IP Devices
Chapter 7 – PING Commands for All
Set Commands
#PINGNUM – Number of PING Requests
Definition:
Syntax:
Values:
Default:
#PINGREMOTE – IP Address of PING Request
Definition:
Syntax:
Values:
Default:
#PING – Start PING Request
Definition:
Syntax:
Values:
#PINGDELAY – PING Delay Time
Definition:
Syntax:
Values:
Default:
Universal IP AT Commands Reference Guide (Document S000457G)
Downloaded from Elcodis.com electronic components distributor
Universal IP Devices
This command sets the number of PING echo requests to issue to PINGREMOTE.
Set Value: AT#PINGNUM=<Value>
View Value: AT#PINGNUM? or AT#VPING, AT#VALL
From 0 to 255 inclusive. (If 0, ping indefinite until ETX (0x03) is issued)
4
Sets the IP address up of the remote device to ping.
Set Value: AT#PINGREMOTE="<IP Address Value>"
View Value: AT#PINGREMOTE? or AT#VPING, AT#VALL
32-bit number is dotted-decimal notation (i.e., xxx.xxx.xxx.xxx) or
None
Directs the module to start PING requests to the configured PING remote address. No of
requests to be sent is obtained from the PINGNUM parameter.
Set Value: AT#PING
View Value: AT#PING?
Read parameters: (read from serial flash predefined before starting the ping command.)
PINGNUM
PINGREMOTE
This command sets the waiting delay, in seconds, before an echo request is considered as a no
reply. It is also the delay between two echo requests (if PINGNUM > 1).
Set Value: AT#PINGDELAY=<Value>
View Value: AT#PINGDELAY?
From 1 to 255 inclusive.
1
Chapter 7 – PING Commands
38