Multitech SocketModem iCell MTSMC-G2-IP At Commands Reference Manual page 83

Part 6 – Commands for GPS-Enabled Devices
#GPSURAIS – Set GPS Unique Remote Asset Identification String
Definition:
Syntax:
Values:
Default:
Result Codes:
#GPSINTERVAL – Set GPS Server Transmission Interval
Definition:
Syntax:
Values:
Default:
Result Codes:
#GPSPW – Set GPS Host Login Password
Definition:
Syntax:
Values:
Default:
Result Codes:
#GPSGPGGA – Enable/Disable GPGGA Message
Definition:
Syntax:
Values:
Default:
Result Codes:
Universal IP AT Commands Reference Guide (Document S000457G)
Downloaded from Elcodis.com electronic components distributor
This command is used to set a unique remote access identification string for each device or
vehicle.
Set Value: AT#GPSURAIS="<value>"
View Value: AT#GPSURAIS? or AT#VGPS or AT#VALL
Up to 20 characters in an alphanumeric string
Note: The ID precedes the GPSPREFIX.
" "
OK
Otherwise ERROR
This command sets the interval of time between messages transmitted to the server.
Set Value: AT#GPSINTERVAL=<value>
View Value: AT#GPSINTERVAL? or AT#VGPS or AT#VALL
0 to 65535 (seconds)
0 (Disabled)
OK
Otherwise ERROR
This command sets the GPS host login password, if required. Some GPS hosts may require a
simple password login mechanism.
Set Value: AT#GPSPW="<value>"
View Value: AT#GPSPW? or AT#VGPS or AT#VALL
Alphanumeric ASCII text string up to 64 characters.
None
OK
Otherwise ERROR
This command enables or disables the reporting of NMEA GPGGA messages.
Set Value: AT#GPSGPGGA =<value>
View Value: AT#GPSGPGGA? or AT#VGPS or AT#VALL
0 Disable
1 Enable
1
OK
Otherwise ERROR
Chapter 16 – Commands for GPS-Enabled Devices
83