Multitech SocketModem iCell MTSMC-G2-IP At Commands Reference Manual page 76

Part 4 – Commands for the SocketModem iCell, SocketModem IP, SocketModem GPRS and MultiModem iCell
#GPRSMODE – Activate Switching Between GSM and GPRS
Definition:
Syntax:
Values:
Default:
Display Commands
#DISPLAYIP – Display IP Addresses
Definition:
Syntax:
Response:
Values:
#VPPP – Display PPP Parameters
Definition:
Values:
Syntax:
Universal IP AT Commands Reference Guide (Document S000457G)
Downloaded from Elcodis.com electronic components distributor
#GPRSMODE configures the activation of the software for switching between GSM and GPRS.
Set Value: AT#GPRSMODE=<value>
Get Value: AT#GPRSMODE? or AT#VGPRS, AT#VALL
0 Configured for GSM use.
1 Configured for GPRS use.
1
This command allows the attached host to view the attributed IP addresses that have been
attributed during the IPCP phase of the PPP negotiation. Both local and remote PPP peer IP
addresses are displayed. This command should be issued only once the PPP OK message has
been received from the TCP/IP stack.
AT#DISPLAYIP
MY IP: xxx.xxx.xxx.xxx
PEER IP: xxx.xxx.xxx.xxx
Read Parameters:
PPPMYIP
PPPPEERIP
This command directs the TCP/IP stack to display all the AT# parameters related to the PPP
layer configuration.
Read Parameters:
ISPPW
ISPUN
PPPMYIP
PPPPEERIP
AT#VPPP
Command Possible Responses
AT#VPPP #ISPUN: "myispun"
#ISPPW: "myisppwd:
#PPPMODE: 1
#PPPMYIP: "0.0.0.0"
#PPPPEERIP: "0.0.0.0"
OK
Chapter 14
76