Multitech SocketModem iCell MTSMC-G2-IP At Commands Reference Manual page 58

Part 3 – Commands Wi-Fi Devices
#WLANIBSSCHANNEL – Channel for Ad-Hoc Mode
Description:
Syntax:
Values:
Default Value: 9
#WLANCONNECT – Connect with AP
Description:
Syntax:
Values:
Example:
#WLANDISCONNECT – Disconnect with AP
Description:
Syntax:
Values:
Example:
#WLANENABLE – Auto Connect Module with AP
Description:
Syntax:
Values:
Default:
Universal IP AT Commands Reference Guide (Document S000457G)
Downloaded from Elcodis.com electronic components distributor
Sets channel for Ad-Hoc mode.
Note: The module must be reset to put the command into effect.
Set Value: AT#WLANIBSSCHANNEL=<value>
View Value: AT#WLANIBSSCHANNEL?
1 – 13
Connects the module with AP.
Set Value: AT#WLANCONNECT
None
at#wlanconnect
SSID : WestConfRoom
RSSI : -52
Network : BSS
Security : No Enc
Capability : 0x1
Channel : 5
WLAN Mode : B Mode
BSSID : 00:13:D3:7B:A3:6A
OK
Disconnects the module with AP.
Set Value: AT#WLANDISCONNECT
None
AT#WLANDISCONNECT
OK
On power up, this parameter determines whether to connect to the AP automatically or manually.
Connection to the AP can be established by AT#WLANCONNECT command. A value of 0
means the module will not connect to AP automatically. A value of 1 means that on power up the
module tries to connect to the AP for configured settings.
Note: The module must be reset to put the command into effect.
Set Value: AT#WLANENABLE=<value>
View Value: AT#WLANENABLE?
0 Manual connection to the AP
1 Automatic connection to the AP
0
Chapter 13 – WLAN Commands for the SocketWireless Wi-Fi (MT810SWM-IP)
58