Multitech SocketModem iCell MTSMC-G2-IP At Commands Reference Manual page 82

Part 6 – Commands for GPS-Enabled Devices
Chapter 16 – Commands for GPS-Enable
#GPSSERV – Set GPS Host Server Address
Definition:
Syntax:
Values:
Default:
Result Codes:
#GPSPORT – Set GPS Host Port
Definition:
Syntax:
Values:
Default:
Result Codes:
#GPSPROTO – Set GPS Host Protocol
Definition:
Syntax:
Values:
Default:
Result Codes:
#GPSPREFIX – Set GPS Message Prefix
Definition:
Syntax:
Values:
Default:
Result Codes:
Universal IP AT Commands Reference Guide (Document S000457G)
Downloaded from Elcodis.com electronic components distributor
This command sets the server IP address or name to which the GPS data will be sent.
Set Value: AT#GPSSERV="<value>"
View Value: AT#GPSSERV? or AT#VGPS or AT#VALL
32-bit number in dotted-decimal notation (i.e., xxx.xxx.xxx.xxx) or
Alphanumeric ASCII text string up to 120 characters if DNS is available.
None
OK
Otherwise ERROR
This command sets the GPS host port (TCP, UDP).
Set Value: AT#GPSPORT=<port number>
View Value: AT#GPSPORT? or AT#VGPS or AT#VALL
1 to 65535
0
OK
Otherwise ERROR
This command sets the server protocol that the GPS will use (TCP, UDP).
Set Value: AT#GPSPROTO=<value>
View Value: AT#GPSPROTO? or AT#VGPS or AT#VALL
0 UDP
1 TCP
0
OK
Otherwise ERROR
This command is used to set a unique identification for each device or vehicle.
Set Value: AT#GPSPREFIX="<value>"
View Value: AT#GPSPREFIX? or AT#VGPS or AT#VALL
Up to 4 characters in an alphanumeric string
Note: The prefix is appended to the NMEA message before transit
" "
OK
Otherwise ERROR
Chapter 16 – Commands for GPS-Enabled Devices
Products
82