Multitech SocketModem iCell MTSMC-G2-IP At Commands Reference Manual page 10

Part 1 – Commands for All Universal IP Devices
Chapter 1 – General AT Commands
Set Commands
AT – Command Mode
Description:
E – Turn Echo ON/OFF
Description:
Syntax:
Values:
I – Identification
Description:
Syntax:
Responses:
Values:
V – Terse or Verbose
Description:
Syntax:
Values:
Display:
Default:
Z – Default Configuration
Description:
Syntax:
Response:
Universal IP AT Commands Reference Guide (Document S000457G)
Downloaded from Elcodis.com electronic components distributor
for Universal IP Devices
If the modem responds OK to the command AT, the modem is in command mode.
Use this command to turn ON/OFF echoing command at the serial terminal.
ATE
ATE0 & ATE turn echo off.
ATE1 turns echo on.
Displays identification parameters.
ATI<value>
For MT100SEM: "1.00 to 1.00g"
For MT810SWM-IP: "1.xx" (Note: "xx" is the number.)
OK
ATI3 – Identifies the firmware version.
ATI5 – Identifies the country. Example: "B5" (MT100SEM example)
Sets terse or verbose responses.
ATVx where x=0,1
ATV0 Sets terse
ATV1 Sets verbose
ATV? Displays the current V setting or use AT#VALL to view all settings.
ATV1
This command restores the configuration profile from NVM. Settings are recalled on power
ATZ
OK (Command valid)
Chapter 1 – General AT Commands
up.
10