Multitech SocketModem iCell MTSMC-G2-IP At Commands Reference Manual page 57

Part 3 – Commands Wi-Fi Devices
Default:
#WLANSCANMODE – Scanning Mode
Description:
Syntax:
Values:
Default:
#WLANSSID – SSID of WLAN
Description:
Syntax:
Values:
Default:
#WLANDATARATE – WLAN Transmission Data Rate
Description:
Syntax:
Values:
Default:
Universal IP AT Commands Reference Guide (Document S000457G)
Downloaded from Elcodis.com electronic components distributor
Country Code Spain:
AT#WLANCOUNTRYCODE="DOMAIN_SPAIN"
Supported Channels - Channel 10 to channel 11
Country Code France:
AT#WLANCOUNTRYCODE="DOMAIN_FRANCE"
Supported Channels - Channel 10 to channel 13
Country Code MKK:- JAPAN
AT#WLANCOUNTRYCODE="DOMAIN_MKK"
Supported Channels - Channel 14
DOMAIN_FCC (For US)
Sets scanning mode. The module can work in both active scanning and passive scanning modes.
In active scanning, the module actively sends a probe request to associate with the AP, and in
passive scanning, the module waits for a beacon from the AP and then it associates.
Note: The module must be reset to put the command into effect.
Set Value: AT#WLANSCANMODE =<value>
View Value: AT#WLANSCANMODE?
0 Active scanning
1 Passive scanning
0 Active scanning
Sets the WLAN network SSID.
Note: The module must be reset to put the command into effect.
Set Value: AT#WLANSSID ="<value>"
View Value: AT#WLANSSID?
Alphanumeric ASCII Text String of up to 32 characters. It will take a blank space also.
mt810swm
Sets the WLAN transmission data rate. "Auto" can be used for auto data rate during data transfer.
Note: The module must be reset to put the command into effect.
Set Value: AT#WLANDATARATE=<value>
View Value: AT#WLANDATARATE?
Auto, 1, 2, 5.5, 9, 11, 12, 24, 36, 48, 54 (in Mbps)
11 (in Mbps)
Chapter 13 – WLAN Commands for the SocketWireless Wi-Fi (MT810SWM-IP)
57