Multitech SocketModem iCell MTSMC-G2-IP At Commands Reference Manual page 69

Part 4 – Commands for the SocketModem iCell, SocketModem IP, SocketModem GPRS and MultiModem iCell
#OUTPORT – UDP/TCP Local Port Number
Definition:
Syntax:
Values:
Default:
Example:
#ATCMD – Set Default Dial Time AT Commands
Definition:
Syntax:
id:
Values:
Defaults:
#REDIALCOUNT – Set Connection Attempts Allowed
Definition:
Syntax:
Values:
Default:
#REDIALDELAY – Set Call Retry Delay
Definition:
Syntax:
Values:
Default:
Universal IP AT Commands Reference Guide (Document S000457G)
Downloaded from Elcodis.com electronic components distributor
Controls the local port that the UDP/TCP connection is bound to.
Set Value: AT#OUTPORT=<Port Number value>
View Values: AT#OUTPORT? or AT#VKEEPALIVE or AT#VALL
Set the port number local connection will use:
From 1 to 5 numeric digits (0 to 9).
Note:
Numbers above 65,535 are illegal since port identification fields are 16-bits long in the IDP
header.
37500
AT#OUTPORT=xxxxx
This command allows the user to customize AT commands on dial up.
Set Value: AT#ATCMD=id,"Valid AT command"
View Value: AT#ATCMD=id or AT#VALL
Enter a Profile Setting: 0, 1, 2, 3 {0,1,2,3}
Set the valid AT command (Do not include AT or issue &F, as the command will error)
For Analog Devices:
For All Other Devices:
This parameter indicates how many unsuccessful connection attempts the TCP/IP stack software
will make before terminating the connection attempt activity.
Set Value: AT#REDIALCOUNT=<value>
Get Value: AT#REDIALCOUNT? or AT#VPHY, AT#VALL
Integer between 0 and 14, inclusive.
If the value is set to 0, the TCP/IP stack software will not make any call retry.
5
This parameter controls the delay (in seconds), if any, that will exist between each call retry.
Set Value: AT#REDIALDELAY=<value>
Get Value: AT#REDIALDELAY? or AT#VPHY, AT#VALL
Integers 0 and 5–14 inclusive.
If this parameter is configured to zero, the TCP/IP stack software will attempt another connection
immediately after terminating the previous unsuccessful attempt.
5
0, "-STE=1"
1, "+MS=V34"
2, ".."
3, ".."
0, ".."
1, ".."
2, ".."
3, ".."
Chapter 14
69