Multitech SocketModem iCell MTSMC-G2-IP At Commands Reference Manual page 13

Part 1 – Commands for All Universal IP Devices
+IPR – Set Serial Speed
Description:
Syntax:
Values:
Display:
Default:
#AUTORESET - Reset the Processor at a Given Time
Definition:
Syntax:
Values:
Default:
#DELFLASH – Erase Flash Memory Parameter Values
Definition:
Syntax:
Values:
Universal IP AT Commands Reference Guide (Document S000457G)
Downloaded from Elcodis.com electronic components distributor
Parity bit settings:
0 - Odd
1 - Even
2 - Mark
3 - Space
4 – None
Note: The input for the command always requires the format value. However, the parity value is
optional and will be set as defined in the table.
Sets the serial speed.
AT+IPR=<serial speed value>
300 to 921600
AT+IPR? Displays the current serial speed.
AT+IPR=? Displays a list of all possible values (serial speeds).
For All Products: 115200
Set an amount of time when the modem will reset after no input has been detected on the serial
port. Note: This command is not supported on the MT100SEM.
Set Value: AT#AUTORESET=<time in minutes>
View Values: AT#AUTORESET? or AT#VALL
0-65535 the time in minutes
From 1 to 5 numeric digits (0 to 9).
0
This command erases the contents of the flash memory and loads with defaults values.
AT#DELFLASH
No parameter values.
Chapter 1 – General AT Commands
13