Multitech SocketModem iCell MTSMC-G2-IP At Commands Reference Manual page 37

Part 1 – AT Commands for All Universal IP Devices
#LUDPSTOP – Close UDP Listening Mode
Description:
Syntax:
Values:
Default Value: None
#OUDP – Initiate UDP Session in Active Mode
Description:
Syntax:
Values:
Default Value: None
Display Command
#VUDP – Display UDP Module Configuration
Description:
Syntax:
Values:
Default Value: None
Universal IP AT Commands Reference Guide (Document S000457G)
Downloaded from Elcodis.com electronic components distributor
This command directs the TCP/IP stack to close a UDP listening mode session previously
launched by the AT#UDPSTART command.
Set Value: AT#LUDPSTOP
UDPPORT
Once an IP link is established, and if no other TCP/IP stack resource is active, this command sent
by the attached host directs the TCP/IP stack to initiate an UDP session in active mode on the
specified UDP remote port UDPPORT to the specified remote IP address UDPSERV.
The host can then transmit to the UDPPORT or UDPSERV address. Datagrams can only be
received from this UDPPORT or UDPSERV address.
Set Value: AT#UDPOPEN
UDPPORT
UDPSERV
UDPTXDELAY
Directs the TCP/IP stack to display all the AT# parameters related to the UDP socket
configuration.
View Values: AT#VUDP
UDPPORT
UDPSERV
UDPTXDELAY
Chapter 6 – UDP Commands
37