Invert Djde - Xerox DocuPrint 100 Software Manual

Using Dynamic Job Descriptor Entries (DJDEs)
Syntax
Options
Option
offset
ZERO
ONE
bitopt
NONE
INKINDEX DJDE:
point to note

INVERT DJDE

Type
Syntax
5-46
INKINDEX = {offset, [ZERO | ONE] [, bitopt] | NONE}
Table 5-35. INKINDEX DJDE options and definitions
Definition
Indicates the byte offset in the data record where the ink index number is
located.
Specifies that the first ink in the list is referenced with an index value of 0.
Specifies that the first ink in the list is referenced with an index value of 1.
bit option
Specifies the number of bits that should be used in calculating the ink index.
The range is 1 through 7.
The default bitopt value is 4.
Specifies that there is no ink index.
If inks are used:
• If one inkref in the list is omitted, commas must be used as
place holders to maintain the relative positioning of the
remaining ink references.
• If more than two ink references are specified, the additional
ink references are ignored.
Specifies that the subsequent page content will be inverted 180
degrees when printed on the physical page. Portrait oriented text
is printed as inverse portrait, landscape text is printed as inverse
landscape, and vice versa.
Page oriented
INVERT = {FRONT | BACK | BOTH | NONE}
Using LCDS Print Description Language