Xerox DocuPrint 100 Software Manual page 359

Parameters that
can be changed
through a JDE
DJDE
Using LCDS Print Description Language
Using Dynamic Job Descriptor Entries (DJDEs)
The parameters that can be changed through a JDE that you
specify in a JDE DJDE are listed in the following table.
Table 5-2. Parameters that are changeable by a JDE DJDE
Command Parameters
ABNORMAL ––
ACCT All parameters
IDEN OPRINFO only
LINE DATA, FONTINDEX, MARGIN, OVERPRINT, PCCTYPE, VFU
MESSAGE All parameters
OUTPUT All parameters except OFFSET
PDE All parameters
RAUX All parameters
RDELETE ––
RECORD LENGTH
RFEED ––
ROFFSET All parameters
ROUTE All parameters
RPAGE All parameters
RRESUME ––
RSELECT ––
RSTACK TEST
RSUSPEND ––
STOCKSET ––
VOLUME TCODE, CODE
NOTE: If a front cover is invoked in a selected JDE that takes
effect after the first page of the report, the cover appears at the
point where the DJDE is applied.
5-7