Xerox DocuPrint 100 Software Manual page 305

Default
OUTPUT NTO1
parameter: points
to note
Using LCDS Print Description Language
NO
The NTO1 parameter interacts with some of the other OUTPUT
command parameters. These interactions can cause some of
the specifications in the JSL to be overridden. In other cases,
you must follow special procedures when specifying the
interacting parameters in your JSL, in order to produce the
results you want.
• N to 1 printing takes longer to process than 1 to n printing
because the system must process the entire report before
beginning to print the job.
• NTO1 and COLLATE: When NTO1=YES, PDL overrides
COLLATE=NO with COLLATE=YES, and notes this action
with a warning in the JSL listing.
• NTO1 and FACEUP: NTO1=YES causes FACEUP=YES to
be specified.
• NTO1 and 1TON: The system assumes each report is NTO1
until the first data page, even if 1TON is specified in the JDE
or JDL. This arrangement allows you to use JDEs and JDLs
that are selected by DJDEs and invoke NTO1 after a series of
banner pages.
The following examples illustrate these conditions:
Example 1:
OUTPUT NTO1= NO is specified.
The job prints 1TON unless a JDE or JDL DJDE specifying
NTO1 is invoked in the first data record after banner pages.
Example 2:
OUTPUT NTO1= YES is specified, and a JDE or JDL DJDE
specifying NTO1= NO is invoked.
The DJDE is processed and the job prints 1TON if the system
encounters it in the first data record after banner pages.
• NTO1 and OSTK: When printing ordered stock in NTO1
sequence using the OSTK parameter, note the following:
The ordered stock must be reverse collated in the feeder so
that the first sheet of the set is on the bottom, the second
sheet next to the bottom, and so on, with the last sheet of the
set on top to be fed first. If the report is larger than the N to 1
threshold, it prints in 1 to N order, and the reverse collated
stock is then inappropriate.
Specifying print format parameters
4-65