Output Bform - Xerox DocuPrint 100 Software Manual

Specifying print format parameters
Table 4-42. Summary of OUTPUT command parameters (Continued)
Parameter
OUTPUT STAPLE
OUTPUT STOCKS
OUTPUT SYSPPR
OUTPUT TMODE
OUTPUT TRANS
OUTPUT UNITS
OUTPUT XSHIFT
Syntax
Options
Option
formid
init
copies
NONE
4-44
Specifies
Places a wire stitch in copied sets of output.
Specifies a STOCKSET for use in the report.
Specifies the system page paper size for a
job.
Specifies a maximum paper width in order to
improve throughput efficiency when mixed
paper sizes are used.
Specifies that transparencies are used in the
job.
Specifies user selected units for positioning
graphics.
Shifts the image upward or downward on the
page.

OUTPUT BFORM

Prints a form on the back side of a duplex data sheet. In
association with the duplex printing mode DUPLEX=YES, a page
containing only a form (no variable data can be printed with this
page) may be printed on the back side of a data sheet. This
feature can be used to print static data on the back of each sheet
in a report without the use of DJDEs or the repetitive processing
of that static data for the back sides of successive sheets.
OUTPUT BFORM = {NONE | (formid [, init [, copies]]
Table 4-43. BFORM parameter options and definitions
Definition
Specifies the name of the back form – a one to six character form file name
(may be numeric, alpha, or alphanumeric), which exists on the system disk.
initial copy.
Specifies the first copy set on which the BFORM will be placed.
Specifies the numbers of copy sets that will contain the BFORM.
Specifies that no form is to be added to the associated report page of variable
data.
Online
[, (INKS, inkref [,inkref
1
Using LCDS Print Description Language
Offline DJDE
Y Y N
Y Y Y
Y Y N
Y Y Y
Y Y N
Y Y N
Y Y Y
] ...)])}
2