Xmp Djde; Xshift Djde - Xerox DocuPrint 100 Software Manual

XMP DJDE

Type
Syntax
Options
Option
DEFAULT
REPORT

XSHIFT DJDE

Type
Syntax
Using LCDS Print Description Language
Using Dynamic Job Descriptor Entries (DJDEs)
• When simplex mode is put into effect, as is done by use of
the TRANS DJDE, the system ensures that the first simplex
page printed after the DJDE is on an odd numbered page. To
accomplish this, the system forces a blank back side for the
last duplex page.
However, if you specify TRANS=NO and DUPLEX=YES, the
system ensures that the first duplex page is printed on an
odd numbered page.
(Xerographic Mode Persistence) Controls the xerographic mode
switching between black and color printing for a report.
Record oriented
XMP = {DEFAULT | REPORT}
Table 5-63. XMP DJDE options and definitions
Definition
Specifies that the xerographic mode switching that was specified at installation
will be used for the report.
Specifies that when the system determines that a report requires highlight color
for a page, all subsequent pages of the report will print in highlight color.
Specifies whether the image of the form and data on a page is to
be shifted, and if so, by what values. This DJDE shifts the data
downward (in the x direction) for short edge binding, because a
long edge feed page is viewed in portrait mode. It is typically
used to accommodate top drilled paper, binding, finishing, and
edgemarking.
Page oriented
XSHIFT = {YES | NO | (v , v )}
1 2
5-73