Dbcode Default; Dbcode Command: Point To Note; Iden Command - Xerox DocuPrint 100 Software Manual

Specifying input parameters
Syntax
Options
Table 2-21. DBCODE DEFAULT parameter options and definitions
Option
codetype
Default

IDEN command

2-24

DBCODE DEFAULT

Specifies a base code from which you can make double-byte
character code assignment exceptions.
The base code is specified by a codetype; the exceptions are
specified in the ASSIGN parameter.
ac: DBCODE DEFAULT = codetype
Definition
Keyword for one the following double-byte codes:
• IBM: Specifies the IBM Nihongo character set (Kanji double-byte sets)
• JEF: Specifies the Fujitsu JEF Kanji double-byte character set.
• JIS
• KEIS: Specifies the Hitachi KEIS Kanji double-byte character set
No default

DBCODE command: point to note

The KCODE command can be used in the same manner as
DBCODE. DBCODE is the preferred usage.
Invokes dynamic job descriptor entry (DJDE) processing.
The IDEN command coded in the JSL notifies the system that
DJDE records may be part of the input data stream. IDEN also
describes the characteristics or search criteria for locating and
identifying DJDE records.
The DJDE record(s) are interspersed among the data records in
the input data stream. Each DJDE record contains an
identification field (which matches the search criteria specified in
the active job) and a series of parameters that describe the
actual JDL changes to be applied to the job.
The following sections describe the syntax of the IDEN
command parameters and explain their options.
Using LCDS Print Description Language