Xerox DocuPrint 100 Software Manual page 244

Specifying print format parameters
Options
Table 4-5. ABNORMAL ERROR parameter options and definitions
Option
CONTINUE
ABORT
STOP
Default
ABNORMAL
ERROR
parameter: points
to note
4-4
Definition
Displays the normal system message defining the abnormal condition and
continues processing the report without applying the offending DJDE
parameter and without offering the operator the choice of resuming or
canceling the job.
Displays the message for the abnormal condition and aborts only the
report it is processing (not the entire job) without offering the operator the
choice of resuming or canceling the job.
Displays the message for stop condition, the system stops processing the
report and waits for the operator to respond by resuming or canceling the
job from the Job Manager window.
STOP
• The CONTINUE and ABORT options put the printer in
"Nonstop" mode. The STOP option puts the system in "Stop"
mode. Any abnormal condition that is detected, such as a
syntax error in a DJDE specification, a missing file referred to
by a DJDE, or an RTEXT or GRAPHIC error in either mode,
results in an appropriate error message being displayed. In
addition, during the Stop mode, the displayed error message
is followed by a DJDE error message to resume or cancel the
job.
• If abnormal conditions are detected while processing DJDEs,
the DJDE parameter set containing the offending entry is set
up to print on the OPRINFO page and an error message is
displayed.
• Errors detected while system is processing RTEXT data are
not reported to you.
• The graphics processing errors are reported separately on
the graphics exception page printed at the end of the report.
Using LCDS Print Description Language