Seffnt Map - Xerox DocuPrint 100 Software Manual

Specifying input parameters
Table 2-49. SEFFNT SEFMAP parameter options and definitions (Continued)
Option
REP
Default
SEFFNT SEFMAP
parameter: points
to note
Syntax
2-46
Definition
REPLACE
Indicates that the specified font pairs create a new mapping table to replace
the current one.
No default
• When specified without a label preceding the SEFFNT
command, SEFMAP puts all font mapping definitions within
the JDL, rather than creating a separate mapping file.
• When SEFMAP is coded outside of a standard JSL (either
prior to a JDL command or after an END command), the
system creates a file named label.LIB on the disk. This file
contains the font mappings for reference within the JSL by
other JSLs or through a DJDE.
NOTE: The .LIB file that is created by a labeled SEFFNT
command cannot be imported to, or exported from, the DP
EPS. You must compile the JSL that contains the labeled
SEFFNT command, which causes the system to recreate the
.LIB file.
• When coded at the catalog level of a JSL, SEF mapping
applies to all JOBS or JDEs that include the catalog. When
coded at the job level, SEF mapping specifically assigns a
mapping to be used with this JOB or JDE.
• In the parameter (font
is mapped to font
imply that font
1

SEFFNT MAP

References a previously defined font mapping file (filename) or a
labeled SEFFNT command defined in the current JSL file.
SEFFNT MAP = {filename | label}
, font ) (font ,font
1 2 2
and font is mapped to font
2 2
is mapped to font .
3
Using LCDS Print Description Language
), the fact that font
3 1
does not
3