Output Ostk - Xerox DocuPrint 100 Software Manual

Specifying print format parameters
OUTPUT OFFSET
parameter: point
to note
Syntax
Options
Option
stockdef
mod
pos
RES
NORES
TABS
size
4-68
The OFFSET control of FIRST, ALL, or NONE may be modified
by the ROFFSET command (refer to the ROFFSET command
description in the "Using logical processing" chapter).
If OUTPUT OFFSET=FIRST (or ALL) was specified, and the
ROFFSET criteria is satisfied on the first page of a report, the
normal offset from the preceding report occurs.

OUTPUT OSTK

Specifies that ordered stocks are used for printing the job.
OUTPUT OSTK = {ostkspec | (ostkspec, ostkspec, ...)}
where ostkspec is:
(stockdef, [mod], [pos], [{RES | NORES}], [TABS], [size {DOTS |
IN | CM}]] [, {L | P}])
Table 4-67. OUTPUT OSTK parameter options and definitions
Definition
stock definition
The identifier or name of the ordered stock to be used, and for which feeder
trays have been identified on the user interface Stock List.
No default.
modulus
The number of sheets in the ordered stock. For example, 5 cut tabs would have
a mod value of 5. The range of values is from 1 to 255.
The default modulus definition is 1.
position.
The initial position relative to the mod value. The range of values is between 1
and mod.
The default position is 1.
RESET or NO RESET.
Indicates whether the pos value should be reset at the start of the next report.
The default is RES.
Indicates a tab stock is being used.
The default is no tabs (no option entered).
Width of the tab. The value can be specified in DOTS, IN, or CM. This
parameter applies only when tabs are specified.
The default is 0.5 in.
Using LCDS Print Description Language