Volume Kcode; Volume Label - Xerox DocuPrint 100 Software Manual

Syntax
Options
Table 2-66. VOLUME KCODE parameter options and definitions
Option
keyword
id
Default
Syntax
Options
Table 2-67. VOLUME LABEL parameter options and definitions
Option
label-type
Using LCDS Print Description Language

VOLUME KCODE

Specifies which double-byte character code translation table the
system will use to interpret the input data.
VOLUME KCODE = {keyword | id }
Definition
Specifies a specific, standard, system defined double-byte code translation
table. The available options are:
• IBM: IBM Nihongo character set (Kanji double-byte character sets)
• IBMCHN: IBM 5550 code translation table
• JEF: Fujitsu JEF Kanji double-byte character set
• KEIS: Hitachi KEIS Kanji double-byte character set
• UCS2: ISO/IEC 10646 UCS2 character set
• USER: Refers to the single unlabeled KCODE command defined within
the JDL or JDE.
Specifies an identifier label that was used in a previously defined KCODE
command to refer to a specific, user-defined code translation table. The id label
is required when multiple KCODE commands are contained within the JDL.
No default

VOLUME LABEL

Specifies the type of label on the input tape.
VOLUME LABEL = label type
Definition
Specifies the type of label that the tape contains. The following types
may be specified:
• COBOL (Honeywell 2000 COBOL tape with 120-byte labels)
• NONE (the input tape is unlabeled)
• ANSI/XEROX ANSI
• SPR (Honeywell 2000 System Print Tape)
• STANDARD
• UNDEF (Input tape label is not defined)
Specifying input parameters
2-63