Output Stocks - Xerox DocuPrint 100 Software Manual

Specifying print format parameters
OUTPUT STAPLE
parameter: points
to note
Syntax
Options
Table 4-75. OUTPUT STOCKS parameter options and definitions
Option
stocksetname
Default
4-80
• The STAPLE command must be specified in the initial JDL/
JDE, or the JDL/JDE DJDE record must be the first record
processed. If there is a banner page in front of the JDL/JDE
DJDE record, the STAPLE command is ignored.
• If the NTO1=YES and STAPLE=YES parameters are
specified, the system overrides NTO1=YES with NTO1=NO
and places an error message in the listing file when the JSL
is compiled.
• Individual sheets cannot be offset when they are coded in the
JSL. To maintain consistent face-up orientation while stitched
and unstitched jobs are delivered to the stacker, you may
print unstitched sets N-to-1, provided that the system does
not encounter the override conditions that have been defined.
• DP 75/90 systems: Jobs greater than 50 pages are not
stapled. The default behavior is to fault the job, with no error
message displayed. If you want the job to print without any
finishing, do the following in the Overprint Finishing section of
the Finishing window:
1. Select [Print Job Unfinished].
2. Select [Check Set–Size] before Printing.

OUTPUT STOCKS

Identifies the stockset and its associated stocks that will be used
for a report. This stockset file (STOCKSETNAME.STK) must
have been created previously via compilation of a JSL and must
currently be stored in the "lcds" resource folder.
OUTPUT STOCKS = stocksetname
Definition
Specifies the stockset to be used for the job.
No default.
Using LCDS Print Description Language