Sf1Function Djde - Xerox DocuPrint 100 Software Manual

Using Dynamic Job Descriptor Entries (DJDEs)

SF1FUNCTION DJDE

Type
Syntax
Options
Table 5-55. SF1FUNCTION DJDE options and definitions
Option
YES
NO
5-66
Example 2:
SEFMAP=((font1,font7), (font5,font6),REP);
Before the above SEF DJDE was processed, the contents of the
memory font mapping table were:
((font1,font2), (font3,font4))
After this SEFMAP DJDE is processed, the contents of the
memory font mapping table are:
((font1,font7), (font5,font6))
Specifies to the third party finisher whether or not it should
perform the user defined SF1 operation on the current sheet.
The SF1FUNCTION DJDE invokes the C6 signal of the
electronic interface between the printing system and a third party
finishing device. The user must specify what function SF1 will
have. (Refer to your finishing equipment vendor documentation
for more detailed information.)
Page oriented
SF1FUNCTION = {YES | NO}
Definition
Instructs the third party finisher to begin the user defined SF1 operation on the
current sheet.
Instructs the third party finisher not to perform on the current sheet the
operation defined as SF1.
Using LCDS Print Description Language