Criteria Command Parameters; Criteria Change - Xerox DocuPrint 100 Software Manual

Using logical processing
Table 3-7. Summary of CRITERIA command parameters
Parameter

CRITERIA CHANGE

CRITERIA CONSTANT
CRITERIA LINENUM
CRITERIA VALUE
Syntax
3-14

CRITERIA command parameters

A CRITERIA command may contain only one specification of
one of these parameters: CONSTANT, CHANGE, or VALUE. In
addition, it may optionally contain the LINENUM parameter.
Thus, one or two parameters must be provided in the CRITERIA
command.
The following table summarizes the CRITERIA command
parameters and gives their uses and functions.
Specifies
Specifies the Change mode criteria for a
logical processing function; that is, the length
and location of a control field in each record,
to which the content of the preceding record is
compared.
Specifies the Constant mode criteria for a
logical function; that is, the location and length
of a fixed field within a record that will be
searched for a constant (also specified by this
parameter).
Specifies the range of numbers of consecutive
lines on which records will be tested for the
specified criteria.
Specifies a magnitude comparison between
numeric character strings
CRITERIA CHANGE
Defines test specifications for a logical processing function with
Change mode criteria. Specifies the length and location of a
control field in each record, to which the next record is
compared. When the content of one record differs from the
content of the control field of the previous record, the criteria test
is TRUE.
ac: CRITERIA CHANGE = (offset, length, NE, LAST)
Online
Y
Y
Y
Y
Using LCDS Print Description Language
Offline DJDE
Y N
Y N
Y N
Y N