Quasonix TIMTER Installation And Operation Manual page 87

This example display shows selected parameters for one channel.
CRateB0
(b/s)
7812666
Examples:
SY ? Help
SY Show the current system status reporting period
SY 5000 Set the status output period to 5 seconds
SY 5000 100 Set the status header output once every 100 status updates
4.2.3.1.20 External Device Control Command – XDC
The XDC command controls the state and operation of the new TTL output pins on the switchbox interface
connector.
**Currently used only by Dual Transmitter with XD option only
The user can manually set the output to 0, 1, or Automatic as follows.
In automatic mode, the actual XDC outputs are based on current frequency and the XDF and XDP settings.
Note that these are channel specific. If you are on Channel 3, both change together. On either Channel 1 or Channel
2, you change only that channel.
79 Quasonix, Inc.
CFRate1
(b/s)
0
Connector: Male MDM-9
Pin
1 Ground
2 **XDC Control Ground
3 **CH1 XDC Control Out
4 No Connection
5 Transmitter Replies to Switch Box
6 3.3VDC + Output
7 No Connection
8 **CH2 XDC Control Out
9 Switch Box Commands to Transmitter
TIMTER™ Multi-mode Dual
Mode 1 Freq 1
(Hz)
0 1852000000
Function
Telemetry Transmitter
Temp 1
(C)
32.5