Quasonix TIMTER Installation And Operation Manual page 6

TIMTER™ Multi-mode Dual
Telemetry Transmitter
Figure 3: Bench Heat Sink and Power Supply ............................................................................................ 14
Figure 4: Bench Heat Sink shown with 6 cubic inch TIMTER™ ................................................................. 14
Figure 5: Airborne IntelliCool™ Heat Sink, Pigtail Cable, and SMA Extender ........................................... 15
Figure 6: Close-up Using Female MDM-15 Connector ............................................................................... 16
Figure 7: Close-up Using Male MDM-15 Connector ................................................................................... 16
Figure 8: Two Airborne IntelliCool™ Heat Sinks Connected to 4 x 3 Dual Transmitter (24xx Package) ... 16
Figure 9: One 4 x 3 Airborne IntelliCool™ Heat Sink Connected to a 4 x 3 Dual Transmitter (24xx
Package) ..................................................................................................................................................... 17
Figure 10: Pre-wired MDM-15 with 36" Pigtails for RS-422 ........................................................................ 17
Figure 11: Pre-wired MDM-15 with 36" Pigtails for TTL .............................................................................. 18
Figure 12: MDM-15 Socket Connector on an RS-422 Transmitter ............................................................. 18
Figure 13: MDM-15 Cable Harness Used with RS-422 Transmitters ......................................................... 18
Figure 14: MDM-15 Pin Connector on a TTL Transmitter .......................................................................... 19
Figure 15: MDM-15 Cable Harness Used with TTL Transmitters ............................................................... 19
Figure 16: USB to Serial Converter Cable .................................................................................................. 20
Figure 17: Switch Box with 18" MDM-9 to MDM-9 Cable Harness ............................................................. 20
Figure 18: 7.2 in3 TIMTER™ Dual Transmitter .......................................................................................... 21
Figure 19: Dual Transmitter RF Outputs ..................................................................................................... 21
Figure 20: Dual Transmitter RF Outputs Connected to Upper and Lower Antenna ................................... 22
Figure 21: Dual Transmitter RF Outputs Connected to Upper and Lower Antenna Transmitting to
Receiver in STC Mode ................................................................................................................................ 23
Figure 22: Outline Drawing, TIMTER™ Dual Transmitter, 07AH Package, S-band Female MDM-15....... 24
Figure 23: Outline Drawing, TIMTER™ Dual Transmitter, 07AN Package, S-band Male MDM-15 ........... 25
Figure 24: 24.0 in3 TIMTER™ Dual Transmitter ........................................................................................ 26
Figure 25: Outline Drawing, TIMTER™ Dual Transmitter, 24AA Package, Male MDM-15 ........................ 27
Figure 26: Example Quasonix Pinout Drawing ........................................................................................... 29
Figure 27: Baseband Signal Timing ............................................................................................................ 30
Figure 28: TIMTER™ Welcome Message .................................................................................................. 32
Figure 29: PCM/FM (Tier 0) Power Spectral Density with Mask ................................................................ 91
Figure 30: SOQPSK-TG (Tier I) Power Spectral Density with Mask .......................................................... 91
Figure 31: MULTI-h CPM (Tier II) Power Spectral Density with Mask ....................................................... 92
Figure 32: Phase Noise Limit Curve ........................................................................................................... 93
Figure 33: Vibration / Shock Testing System .............................................................................................. 94
Figure 34: TIMTER™ Mounted for Z-axis Testing ...................................................................................... 94
Figure 35: TIMTER™ Mounted for X-axis Testing ...................................................................................... 95
Figure 36: TIMTER™ Mounted for Y-axis Testing ...................................................................................... 95
Figure 37: TIMTER™ Vibration Profile ....................................................................................................... 95
v Quasonix, Inc.