Table of Contents
Advertisement
The following figure shows a typical three-connector IDE
cable. If your IDE cable is not keyed with a connector tab,
align the colored edge of the cable with the pin 1 side of the
drive connector and system board IDE port connector.
Pin 1 on the system board IDE connectors is on the
connector end closest to the rear of the system.
Storage Device Installation
Use the appropriate procedures to install storage devices in
your system:
To install storage devices in the desktop, see "Installing
a Storage Device in the Desktop."
To install storage devices in the minitower, see
"Installing a Storage Device in the Minitower."
Optional IDE cable connectors
Adding Options 5-55
Advertisement
Table of Contents
