Supermicro SuperServer SYS-122H-TN User Manual page 168

Note: This feature is NOT available when "Workload Profile" is set to Telco NFVI, Telco
NFVI-FP, or Telco FlexRAN.
C1 to C1e Promotion
If this feature is set to Enabled, CPU will run at its minimum frequency for lower power
consumption in the C1 state. The options are Disabled and Enabled. This feature is CPU-
dependent.
Note: This feature is available when "Workload Profile" is set to Disabled.
ACPI C1 Enumeration
Use this feature to select the ACPI C1 state or the ACPI C1e state. The options are C1 and
C1e. This feature is CPU-dependent. (ACPI is the abbreviation for Advanced Configuration and
Power Interface.)
Note: This feature is available when "Workload Profile" is set to Disabled.
ACPI C6x Enumeration
Use this feature to configure C6 state or C6 P-state as ACPI C2 or ACPI C3 state. The options
are Disabled, C6S as ACPI C2, C6S as ACPI C3, C6S-P as ACPI C2, C6S-P as ACPI C3, and
Auto.
Note: This feature is available when "Workload Profile" is set to Disabled.
Package C State Control Menu
►Package C State Control
Note: This submenu is available when "Power Performance Tuning" is set to BIOS
Controls EPB.
Package C State
Use this feature to optimize and reduce CPU package power consumption in the idle mode.
Please note that the changes you've made in this setting will affect all CPU cores or the circuits
of the entire system. The options are C0/C1 state, C2 state, C6 (non Retention) state, No Limit,
and Auto.
SuperServer SYS-122H-TN: UEFI BIOS
168