Table of Contents
Advertisement
An IDE device, such as an IDE hard disk or IDE CD-
ROM reader, must be set correctly as the first (master)
or second (slave) device on the IDE channel.
The standard IDE hard disk (in hard disk models) is set
as the master device on the primary IDE connector. The
CD-ROM reader in multimedia models is the master
device on the secondary IDE connector.
SCSI device
before you install it. See the documentation that comes
with the device for jumper setting information.
Each SCSI device must have a SCSI ID number set for
the device. The SCSI adapter board can have as many as
seven devices connected to the board (internal and
external). The last device on the internal and external
cable must be terminated. The SCSI adapter board is set
to SCSI ID number 7 and the internal SCSI drive is set
to SCSI ID number 0.
Device Cables
The cables used for installation of optional storage devices
include:
diskette drive signal cable
IDE signal cable
SCSI signal cable
system power cables.
The diskette drive and IDE cables shipped with the system
each support two devices. Cable connector locations on the
system board are shown in the following figure.
5-26 Installing Options
check the jumper settings on the device
Advertisement
Table of Contents
