Changing Network Settings On Systems With The Microsoft Windows Nt Operating System - NEC POWERMATE ES SLIMLINE - RELEASE NOTES 2001 Release Note

Changing Network Settings on Systems with the Microsoft Windows NT
Operating System
All systems are configured with the NetBEUI and NWLink protocols enabled. However, before
you connect a system to your network you might need to:
!
enable a different network protocol
!
disable unneeded protocols for enhanced system performance
! add or change network, domain, and gateway information.
The following procedure describes how to disable the NetBEUI and NWLink protocols, enable
TCP/IP, and provide network, domain, and gateway information. (If a different protocol is
enabled, the menu choices might differ from those described in the procedure.)
From the Windows desktop, click
1.
Panel .
Double click the
2.
3. Click the
loaded:
NetBEUI Protocol
NWLink IPXSPX-Compatible Transport
NWLink NetBIOS
Highlight
4.
appears asking for confirmation to continue.
Click
5. Yes
disappear from the Configuration display.
6. Repeat steps 4 and 5 to remove the NetBEUI Protocol.
In the Configuration tab display, click
7.
8. Highlight
there is a DHCP server on the network, click
9. Change the path in the window to
If Yes was clicked in step 8, skip to step 16. If No was clicked in step 8, the Windows Setup
window appears.
Click
10. Close
11. Fill in the
address" area.
Click the
12.
Click the
13.
Click the
14.
15. Click the
Click
16. OK
4 NEC PowerMate ES SlimLine Series Release Notes
Start
icon in the Control Panel window.
Network
Configuration tab. In the Configuration display, the following protocols are
NWLink IPXSPX-Compatible Transport
. The NWLink IPXSPX-Compatible Transport and NWLink NetBIOS lines
Microsoft and then TCP/IP
C:\I386
. The Microsoft TCP/IP Properties Box appears.
IP Address , the Subnet Mask
tab and enter the host and domain name in the DNS display.
DNS
tab and change the Computer Name if appropriate.
Identification
tab and enter the WINS address if appropriate.
WINS
Routing tab and enable IP forwarding if appropriate.
. When prompted to restart the system, click
on the taskbar, point to
Settings
and click
Remove
. Highlight
Add Protocol
and click OK . The TCP/IP Setup window appears. If
; otherwise click
Yes
. Click Continue . The Network window appears.
, and the Default Gateway
.
Yes
, and click
Control
. A warning window
and click .
Add
.
No
in the "Specify an IP