Beeper - Tektronix KEITHLEY System SourceMeter 2636B Reference Manual

Section 3: Instrument description
To edit compliance limit values:
1. Press the LIMIT key.
2. Select the type of compliance.
3. Press the navigation wheel or the ENTER key to enter edit mode. The EDIT indicator is
illuminated.
4. Change the compliance value (see
5. When finished, press the ENTER key (the EDIT indicator is not illuminated).
The up and down range keys change the format of the limit value.

Beeper

The Series 2600B includes a beeper. When it is enabled, a beep indicates one of the following
actions have occurred:
•
A front-panel key was pressed: A short beep, similar to a key click, is issued.
•
The navigation wheel
•
The output source was changed: A longer beep is issued when you select the OUTPUT ON/OFF
control (turn the output on or off).
To turn the beeper on or off from the front panel:
1. Press the MENU key, and then select BEEPER.
2. Select one of the following:

ENABLE

DISABLE
To turn the beeper on or off from the TSP command interface:
Set the beeper.enable attribute. For example, to enable the beeper, send:
beeper.enable = 1
3-20
Series 2600B System SourceMeter® Instrument Reference Manual
Setting a value
was turned or pressed: A short beep is issued.
(on page 3-18)).
2600BS-901-01 Rev. E / January 2019