Tektronix KEITHLEY System SourceMeter 2636B Reference Manual page 524

Section 11: TSP command reference
localnode.reset()
This function resets the local node instrument.
Type TSP-Link accessible
Function Yes
Usage
localnode.reset()
Details
If you want to reset a specific instrument or a subordinate node, use the node[X].reset()
command.
A local node reset includes:
•
Source-measure unit (SMU) attributes affected by a SMU reset are reset
•
Other settings are restored back to factory default settings
A localnode.reset() is different than a reset() because reset() resets the entire system.
When using this command from a remote node, localnode should be replaced with the node
reference, for example node[5].reset().
Example
localnode.reset()
Also see
reset() (on page 11-172)
smuX.reset() (on page 11-234)
localnode.revision
This attribute stores the firmware revision level.
Type TSP-Link accessible
Attribute (R) Yes
Usage
revision = localnode.revision
revision
Details
This attribute indicates the revision number of the firmware that is presently running in the instrument.
When using this command from a remote node, localnode should be replaced with the node
reference. For example, node[5].revision.
11-156
Series 2600B System SourceMeter® Instrument Reference Manual
Affected by Where saved
Resets the local node.
Affected by
Not applicable
Firmware revision level
Default value
Where saved Default value
Not applicable Not applicable
2600BS-901-01 Rev. E / January 2019