Chapter 3 Installing The Router; Workplace Conditions; Removing/Installing The Connector Protector - Teldat Regesta Smart PRO Manual

Teldat S.A.

Chapter 3 Installing the Router

This chapter describes the steps to successfully install the Regesta Smart PRO router. It is divided into the following
sections:

3.1 Workplace Conditions

Warning
This equipment must be installed in restricted access areas. Only trained and qualified personnel
should install, replace, or service this equipment, following the instructions outlined in this installation
guide.
• Avoid placing the device among papers, magazines, or other objects that may impede natural air circulation.
• Prevent knocks and strong vibrations during transport, operation, and storage to avoid potential damage.
Warning
Electricity in power, telephone, and communication cables can be dangerous. To prevent electric
shocks, follow safety precautions before installing, handling, or opening equipment covers. Always ad-
here to the procedures outlined in the sections

3.2 Removing/Installing the Connector Protector

The Regesta Smart PRO includes a protective case designed for the connectors to prevent accidental electrical dis-
charges. With the protective case in place, direct contact with the connectors is prevented during use.
Warning
This unit may have multiple power supply connections. Ensure that all connections are disconnected
before turning off the device.
Follow these steps to remove the protective case covering the connectors:
Find the fastening mechanism located in the middle of the front panel. Rotate the fastening mechanism 90º to the left
or right to bring it to a vertical position.
Refer to the following figures for visual guidance on how to remove the protective case from the device.
Regesta Smart PRO
• Workplace Conditions on page 15
• Removing/Installing the Connector Protector
• Installing a DIN Rail Mount
• Wall Mounting on page 18
on page 15
on page 17
Connecting on page 22 andDisconnecting on page 22.
3 Installing the Router
15