Debug Ip Igmp Snooping - Cisco Catalyst 3750 Command Reference Manual

debug ip igmp snooping

debug ip igmp snooping
Use the debug igmp snooping privileged EXEC command to enable debugging of Internet Group
Management Protocol (IGMP) snooping activity. Use the no form of this command to disable debugging
output.
Syntax Description
group
management
router
timer
Defaults
Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.1(11)AX
Usage Guidelines The undebug ip igmp snooping command is the same as the no debug ip igmp snooping command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you must start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member.
Related Commands Command
debug platform ip
igmp snooping
show debugging
Catalyst 3750 Switch Command Reference
B-14
debug ip igmp snooping [group | management | router | timer]
no debug ip igmp snooping [group | management | router | timer]
(Optional) Display IGMP snooping group activity debug messages.
(Optional) Display IGMP snooping management activity debug messages.
(Optional) Display IGMP snooping router activity debug messages.
(Optional) Display IGMP snooping timer event debug messages.
Modification
This command was introduced.
Description
Displays information about platform-dependent IGMP snooping activity.
Displays information about the types of debugging that are enabled. For
syntax information, select Cisco IOS Release 12.2 Configuration Guides
and Command References > Cisco IOS Configuration Fundamentals
Configuration Guide, Release 12.2 > System Management >
Troubleshooting and Fault Management.
Appendix B Catalyst 3750 Switch Debug Commands
78-16181-01