Turning The Device On And Off - Technogym SKILLRUN UNITY 7000 Technical Service Manual

SKILLRUN
Technical Service Guide - Rev. 6.0
5.6

TURNING THE DEVICE ON AND OFF

To turn the device on, move the main on/off switch to position ON "I". After a quick self-check
(reset) the device is ready to be used.
To turn the device off, move the main ON/OFF switch to position OFF "0". Turn off the device only
at the end of the workout when it is in stand by.
If the product is not expected to be used for a long time, as well as turning it off, the plug should
also be removed from the wall socket.
Depending on the product version, the ON (I) and OFF (O) position can change; for the exact position
check the drawing above the switch.
ATTENTION: The switch is used to turn the equipment on and off, but it does not isolate it
completely from the mains voltage, not even when it is in the OFF"0" position. For com-
plete isolation, the power supply plug must be disconnected. If the product is not powered,
the rotating belt will turn freely. Hold onto the side supports when getting on and off the
equipment.
Uncontrolled copy if printed
Figure 61
Pag. 89