Procedure For Restoring The Low Kit Factory Settings; Message On The Display: 'The Equipment Is Blocked. Contact Technogym Technical Support; Message On The Display: 'Communication Error - Press "Yes" To Quit This Message - Technogym SKILLRUN UNITY 7000 Technical Service Manual

SKILLRUN
Technical Service Guide - Rev. 6.0
6.5

PROCEDURE FOR RESTORING THE LOW KIT FACTORY SETTINGS

1. For UNITY 3.0: On the stand-by screen, press and hold the touch screen, to the right of the
HOME logo, for approx. 4 seconds.
For TX interface: press and hold the touch screen at the bottom right.
2. Use the virtual keyboard to enter the numerical value 2501. This accesses the SERVICE menu.
3. Click the "LOW KIT" menu item.
Set the parameter 802 = 1 (factory reset command)
Set the parameter 800 = 1 (command that saves the changes)
4. After the 'factory setting' procedure, the standard setting MUST be carried out.
ATTENTION: Remember to check the PAR 5 parameter to understand if DCLINK functions
correctly. The value read must be around 400 Vdc.
6.6 MESSAGE ON THE DISPLAY: 'THE EQUIPMENT IS BLOCKED. CONTACT
TECHNOGYM TECHNICAL SUPPORT'
All the Low Kit errors, with the exception of the errors:
▪ 7 (gradient motor) ("6.10 Message on the display : 'DC MOTOR FAULT –PRESS "YES"
TO QUIT THIS MESSAGE' - error 07 dc gradient motor encoder");
▪ 15 (loss of impulse) ("6.12 Message on the display: 'WARNING: ENCODER MOTOR-
PRESS "YES" TO QUIT THIS MESSAGE' - error 15 LOSS OF IMPULSE");
▪ 16 (Movement of the running surface during the Hold phase) ("6.19 Message on the
display: 'PRESS "YES" TO QUIT THIS MESSAGE AND START TRAINING'")
▪ 17 (Acceleration of the running surface during the hold phase) ("6.19 Message on the
display: 'PRESS "YES" TO QUIT THIS MESSAGE AND START TRAINING'");
▪ Communication error ("6.7 Message on the display: 'communication error - Press "YES"
to quit this message'");
cause the following message to appear on the display 'THE EQUIPMENT IS BLOCKED. CON-
TACT TECHNOGYM TECHNICAL SUPPORT'.
6.7 MESSAGE ON THE DISPLAY: 'COMMUNICATION ERROR - PRESS "YES"
TO QUIT THIS MESSAGE'
Click the button on the display to try to make the error disappear. If the error message remains, the
cause is related to a connection problem between the High Kit and the Low Kit:
▪ Check continuity between PIN 1 (drive side) and PIN 13 (display side) and between
PIN 5 (drive side) and PIN 5 (display side). (cable 0WCU0950xx: High Kit - Low Kit
Uncontrolled copy if printed
Pag. 133