Technogym SKILLRUN UNITY 7000 Technical Service Manual page 110

6. Remove all the slats from the belts.
Remove the felt and install it after tensioning the tread belt
8. Place a protection on the ground where the display and uprights will be placed.
9. Disconnect all the cables that exit the upright. Disconnect the gradient motor cable from the
drive.
Pag. 110
Technical Service Guide - Rev. 6.0
7. Remove the front roller
(42). ("8.19 Disassembling
the front and rear
(from point 10 to point 13).
Uncontrolled copy if printed
SKILLRUN
roller")