Using The Digital Led Operator; Using The Digital Led Operator; Keys, Displays, And Leds - Omron V1000 User Manual

4.2 Using the Digital LED Operator

4.2

Using the Digital LED Operator

Use the LED operator to enter run and stop commands, display data, edit parameters, as well as display fault and alarm
information.
u

Keys, Displays, and LEDs

No. Display
1 Data Display Area
2 ESC Key
3 RESET Key
4 RUN Key
5 Up Arrow Key
6 Down Arrow Key
7 STOP Key
STOP
8 ENTER Key
9 LO/RE Selection Key
10 RUN Light
11 LO/RE Light
66
1
5
2
3
STOP
10
4 6
Table 4.1 Keys and Displays on the LED Operator
Name
Displays the frequency reference, parameter number, etc.
Returns to the previous menu.
Moves the cursor to the right.
Resets the drive to clear a fault situation.
Starts the drive.
Scrolls up to select parameter numbers, setting values, etc.
Scrolls down to select parameter numbers, setting values, etc.
Stops the drive.
Note: Stop priority circuit. A fast-stop is available by pressing the STOP key when
the drive detects a danger even if the drive is running by a signal from the multi-
function contact input terminal (REMOTE is set). To avoid stoppage by using the
STOP key, set o2-02 (STOP Key Function Selection) to 0 (Disabled).
Selects all modes, parameters, settings, etc.
Selects a menu item to move from one display screen to the next.
Switches drive control between the operator (LOCAL) and the control circuit
terminals (REMOTE).
Note: LOCAL/REMOTE key effective during stop in drive mode. If the digital
operator could change from REMOTE to LOCAL by incorrect operation, set o2-01
(LOCAL/REMOTE Key Function Selection) to "0" (disabled) to disable LOCAL/
REMOTE key.
Lit while the drive is operating the motor.
Lit while the operator (LOCAL) is selected to run the drive.
13
12
11
9
15
14
8
7
Function
SIEP C710606 20 OYMC AC Drive - V1000 User Manual